8 Biscuit Joiner Tips for You

Want to be healthy? Start woodworking! This activity of building stuff with wood can improve your heart, mental health, and physical body. Indeed, it’s a creative and fun way to exercise.

But to work with wood means to own a biscuit joiner. If you don’t have one yet, visit http://gardeningandhome.com/best-biscuit-joiner-guide/. If you already do, then learn how to maximize the tool with these steps!

Maintain Its Cleanliness

biscuit-joinerOne of the things you should do is keep cleaning the jointer blade so that it doesn’t heat up and become dull because of the abundance of deposits. You should also avoid working with slots that were once PVA glued.

Elevation is the Key

Some biscuit joiners, no matter how well-tuned they are, can still cut slots that can cause a non-flush-fitting joint. How will you solve this? Elevate your jointer using a sandpaper sheet prior to cutting the face-grain slot. After the assembly, flush-trim the end grain using a router for a perfect fit.

Use a Biscuit Gauge

Want to save time? Use a gauge to display the width of #20, #10, and #0 biscuits as well as the slots which hold them. Grind a slot for every size, then glue it in a biscuit, ensuring that you insert it only halfway, and draw a centerline for each. Next, line the centerline up on your gauge using the layout line on the wood for quick reference. Note that you should utilize the biggest biscuit for optimum strength.

Use the Proper Glue

pva-glue

PVA is usually preferred since the water makes the biscuits expand. In winter, however, PVA freezes, and its chemical components might separate. You could use aliphatic since it has a faster setting time for cold and humid conditions and is also runnier. You could also keep the PVA glue indoors until you need them.

Seal Tightly

Make sure your biscuits are secured in airtight vessels to keep them from bulging and being damp.

Bevel Cuts? Trap Them!

If your fence can’t hold them, especially if it maxes out at 90 degrees, then you’ll have trouble. What you can do to stabilize is to clamp the mating mitered pieces back-to-back so that the bevels can form a 90-degree angle. Then cut the slots on every miter.

Own Every Biscuit Size

biscuit-joiner

You should always have all the three sizes available—0, 10, and 20. Make sure you have lots of size 20, because it’s the most used size and will, therefore, run out faster than the other two.

Get a Base Extension

This will help you stabilize when you’re working on the edge, since a short fence may fail to supply sufficient reference surface to avoid tipping. You could make one using a flat scrap stock or plywood.

Liked this post? Follow this blog to get more. 

Writen by theswiftys